Following the end of the daily production activities, in order to reduce the failure rate of the hollow glass double component breaker, we must do the following
1, two sets of glue machine, after each use, the machine will be residual glue and dust clean, make the machine keep clean.
2, irregular, should be fully checked whether the fasteners are loose, and re tightened. It is recommended to have an investigation every three days!
3, cleaning glue mixer and its pipe before and after the coagulation gel, regular cleaning check valve; found resistance increased or blocked phenomenon, should promptly clean up.
2 、 regularly check whether the electrical wiring is loose and the reliability of the grounding.
In fact, not only is the other equipment of hollow glass two-component glue machine around us also need regular maintenance equipment, in fact we like people, as long as you treat him, care for her, the equipment will also dedicated for you do pay a maximum power to benefit you.
3, there should be enough pressure. At the same time, pay attention not to exceed the joint tooth surface when connecting the pipeline, and eliminate all kinds of metal dust like dirt in the pipe connection.
Usually in maintenance, as long as the connection pipe cleaning, and pay attention to whether the joints are intact, rules can.
4, repair the solenoid valve to open the valve, and pay attention to the replacement of sealing ring, and at the same time after each cleaning, add a small amount of lubricating oil and then loaded.
On the other hand, if you do not take care of the equipment seriously, he will also express his dissatisfaction in various ways, such as equipment failure and strike!
This article is made up of a two component press machine. Our website is: http://www./, we will provide you with better service with your wholehearted enthusiasm, and welcome your visit!